|
- Options for improving TR650 forks. . . . - Cafe Husky
The lowers wouldn't swap between a 46 and 48, but they are a cheap, readily available fork on the used market, and are very adjustable The wheel options would be pretty much, cast 17s or anything you can spoke to a YZ, Husky, Honda, etc, front rim
- 2012 TE 250 310 fuel injection issues - Cafe Husky
My opinion is that 1) Husky really craps up their fuel injection by making the TE TXC emissions compliant However, my husband's 09 carbed TXC 450 needed a fair amount of carb tinkering before it quit shooting flames out of the muffler and 2) Husky suffers from an EXTREME lack of communication
- 82 83 Husqvarna cr500 test stats | Cafe Husky
The production '82 5 500CR used an '82 frame The '82 factory bike ridden by Billy Grossi used a pre-production '83 frame The Husky 500 is not a beast at all, much like the 430 is like the 390 just more everywhere, the 500 is similar to the 430 just more everywhere
- Oil Weights - Cafe Husky
The local Husky shop here in the "day" put 80-90W in them from new, a little clutch drag when cold but it helped with gear spalling thru the hardness in the transmission, opinion of course Scott Old Geezer
- 125-200cc - 125 150 Jetting Database - Cafe Husky
Carb = PWK38AS (Motosportz Husky 125 kit) Pipe Silencer = Stock pipe, OEM Euro3 Enduro no SA Other engine mods = Stock Premix ratio fuel type = 40:1 Spectro Synthetic Temperature range (deg F) = 35-65F Elevation (feet) = 1000-2000 Main jet = 178 Pilot jet = 45 Needle = JD Blue Clip position = 3rd (middle) Air screw setting = 1 5-2 Slide = 7
- 250-500cc WR WXE 250, 1994 -1999 Changes?? - Cafe Husky
Hi all, new husky owner, very tidy low use 1995 WR 250 Bike seems pretty good all over with the exception of faded cracking plastics to be expected with age It is not in my nature to let a toy be just right though I want it to be like a new bike under the skin, so far I am discovering that
- TE TC - Decoding Map Switch Position - Cafe Husky
Trying to figure out which position is which on the OEM dealer installed switch Looking down on the handlebar switch from above, the thumb post can be in the 6 o'clock position and then can be rotated clockwise to the 7 o'clock position Which position is what?
- 125-200cc - Linkage bearings removal. | Cafe Husky
Husky linkage is, as you all probably allready know, not a funny thing to remove and that because of that "bridge" between the bushings so you just can´t squeeze them out in one direction But I found a simple way to do it without any special tools It went quick and without cursing This is how I did it Here it is, the notorious linkage!
|
|
|